If the sparse point cloud does not look correct, re-do this step and try entering different numbers for the “Key Point Limit” and “Tie Point Limit.” See the Agisoft Metashape manual for suggested settings.įor the next step, click on “Workflow” and then select “Build Dense Cloud.” This process is similar to the “Sparse Point Cloud” stage, but it will take much longer because the software analyzes each photo more closely and will build a much denser point cloud. If everything looks like it is in the right place, you can move to the next section. At the end of this process, you will see a series of dots on your screen in the rough outline of what you are trying to model. Once all photos are loaded and any masks and markers are set, select “Workflow” –> “Align Photos.” During this process, Metashape will compare each photo to every other photo. To learn about masking and markers, please consult the Metashape user manual linked above. Spending time on cutting out un-needed space and setting markers (if you have used any) can save hours of time later. In this step, you can edit what portions of your photos Metashape will process. If your photos are contained within a single folder, select “Load Folder.” To begin, select “Load Photos” under the “Workflow” tab if your photos are scattered between folders or you only want to add a certain set of photos. Open the Agisoft Metashape software and follow the steps outlined below to produce a 3D model.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |